Basement Waterproofing Photo Album: Basement Waterproofing in Nashville, TN

Barton in Nashville contacted Frontier after repeated basement flooding throughout the year. After inspecting the space, the design specialist determined that water intrusion required a full drainage and moisture control system. Frontier installed a WaterGuard XL sub-floor drainage system with inspection access, CleanSpace wall liners, a TripleSafe sump pump system with battery backup, and a SaniDry Sedona dehumidifier to keep the basement dry and protected long term.

Digging for the Sump Pump

The TripleSafe sump pump requires 2 feet of vertical space for installation. Our foreman is carving the bedrock to make space for the pump.

Creating the Trench

Field technicians jackhammer the basement floor to create space for the drainage system.

Crushed Rock for Waterproofing

Rocks are used to allow proper water movement within the waterproofing system. Frontier's field technicians shovel the stone into five-gallon buckets and carry it down the basement stairs for installation.

Space for the Drainage System

Minimal space at the edge of the basement is used for the drainage system installation.

SilverGlo Panels

Frontier installed SilverGlo panels to prevent air from leaking into the basement.

Wall Liner

The block wall in this basement allows moisture to seep in. CleanSpace wall liner was installed to direct moisture towards the drainage system.

Finished Drainage System

Concrete is applied over the drainage system to restore the surface of the floor after installation.

TripleSafe Sump Pump

The TripleSafe sump pump collects water from the drainage system and pumps it out of the basement.

IceGuard and LawnScape Outlet

Water is pumped through an IceGuard and out through a LawnScape Outlet. This system allows water to flow away from the house, preventing moisture from reentering the basement.