Basement During Inspection
Moisture and mildew damage can be seen in this basement during the inspection.
Trench Dug
A trench is dug around the basement perimeter to prepare to install the WaterGuard system.
Weep Holes
Weep holes are drilled into the concrete block wall to allow any water to drain into the waterproofing system when it is in place.
WaterGuard Installation Process
Our most popular drainage system, WaterGuard® is the ideal solution for most basement waterproofing applications. Unlike old-fashioned drain tile systems installed on the outside of the home, WaterGuard® is installed just underneath the perimeter edge of the basement floor.
CleanSpace
Once the WaterGuard is in place, CleanSpace is added on top for an extra layer of protection before everything is sealed in place.
TripleSafe Sump Pump
The TripleSafe sump pump is being installed.
TripleSafe Sump Pump Install Complete
Our most reliable sump pump system, the TripleSafe™ Sump Pump System, provides three levels of protection for your basement and your peace of mind. For normal functioning, the TripleSafe™ has a powerful, cast-iron Zoeller® ⅓ horsepower sump pump set at the lowest level. For heavy volumes of water or in case of primary pump failure, a second, more powerful Zoeller® ½ hp pump set a bit higher in the liner will take over.
WaterGuard Install Complete
After the WaterGuard is placed, and CleanSpace is added on top, everything is cemented into place.
Basement Waterproofed
After the WaterGuard is cemented in place and the Triplesafe is assembled, all the drainage lines are connected to carry water out of the basement.
LawnScape Installed
LawnScape™ is a pipe buried from the downspout to a special LawnScape™ outlet that lets the water out onto the surface while camouflaging the end of the pipe. The lid comes off for easy cleaning. LawnScape™ is best used for downspout extensions over 8' long.
4.9