
Trench Dug
A trench is dug around the perimeter of the basement in preparation for placing the WaterGuard drainage system.

Able to waterproof concrete block foundation walls
Weep holes are drilled at the bottom of the blocks to drain the hollow cavities.

Debris Removed
The debris is removed from the excavation, and the WaterGuard is ready to be placed.

WaterGuard Installation
The WaterGuard is placed, surrounded with clean gravel, and the container is set in place for the sump pump.

CleanSpace
A thin layer of CleanSpace is added on top of the WaterGuard system for an added layer of protection.

TripleSafe Sump Pump
Our most reliable sump pump system, the TripleSafe™ Sump Pump System, provides three levels of protection for your basement and your peace of mind. For normal functioning, the TripleSafe™ has a powerful, cast-iron Zoeller® ⅓ horsepower sump pump set at the lowest level. For heavy volumes of water or in case of primary pump failure, a second, more powerful Zoeller® ½ hp pump set a bit higher in the liner will take over.

Cement Added
A thin layer of cement is added on top of the WaterGuard to set everything in place.

WaterGuard Install Complete
The WaterGuard system is now fully installed. Now the water will flow into this system and to the sump pump, and out of the basement.

An Escape Route
Water escapes from the IceGuard® fitting only when the discharge line becomes clogged. Otherwise, water flows past the slotted openings into the drain pipe. LawnScape™ is a pipe buried from the downspout to a special LawnScape™ outlet that lets the water out onto the surface while camouflaging the end of the pipe. The lid comes off for easy cleaning. LawnScape™ is best used for downspout extensions over 8' long.

Drainage Lines Buried
Drainage lines are buried in the ground, and now this basement waterproofing project is complete.