4.9 
Moisture Issues
Moisture is an issue in this basement. There is obvious mold growth on the walls, this problem will continue to get worse unless it is treated and the moisture issue is addressed.
Basement Before Project Begins
Moisture is causing cracks in these foundation walls. This needs to be addressed quickly before the walls start to bow inward and cause structural damage.
Trench Dug
A trench is dug in preparation for the WaterGuard system to be placed. All this old concrete will be removed and the area cleaned up before the waterproofing products are installed.
Trench Complete
The trench is complete, it is dug out around the perimeter of the basement and leads to the sump pump that will pump any water out through the drainage lines into the IceGuard and LawnScape system.
Weep Holes
Weep holes are drilled at the bottom of the blocks to drain the hollow cavities.
WaterGuard Installation
Our most popular drainage system, WaterGuard® is the ideal solution for most basement waterproofing applications. Unlike old-fashioned drain tile systems installed on the outside of the home, WaterGuard® is installed just underneath the perimeter edge of the basement floor.
CleanSpace® Wall System
Like our other wall systems, it can hold back water vapor passing through your foundation walls, directing it to your sump pump. With anti-microbial protection called UltraFresh built right in, no mold or mildew will grow on the CleanSpace!
WaterGuard Installation Complete
After the WaterGuard is placed inside the trench, it is covered with a layer of CleanSpace and cemented in place. Any water seepage from the block wall will be blocked by the CleanSpace and any water from inside the wall will come out through the weep holes into this drainage system.
TripleSafe Sump Pump Installed
Our most reliable sump pump system, the TripleSafe™ Sump Pump System, provides three levels of protection for your basement and your peace of mind. For normal functioning, the TripleSafe™ has a powerful, cast-iron Zoeller® ⅓ horsepower sump pump set at the lowest level. For heavy volumes of water or in case of primary pump failure, a second, more powerful Zoeller® ½ hp pump set a bit higher in the liner will take over.
IceGuard and LawnScape
Water escapes from the IceGuard® fitting only when the discharge line becomes clogged. Otherwise, water flows past the slotted openings into the drain pipe. LawnScape™ is a pipe buried from the downspout to a special LawnScape™ outlet that lets the water out onto the surface while camouflaging the end of the pipe. The lid comes off for easy cleaning. LawnScape™ is best used for downspout extensions over 8' long.